DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

Go Back   DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum > Search Forums


Notices


Latest Vendor News
AutoAnything
Addictive Desert Designs!
Bayou Goat Mounts

Showing results 1 to 25 of 500
Search took 2.47 seconds.
Search: Posts Made By: RamTech
Forum: Prospective Buyers - Question and Answer Forum Yesterday, 01:55 PM
Replies: 3
Views: 77
Posted By RamTech
The PCM relearns the idle strategy from various...

The PCM relearns the idle strategy from various sensors as the vehicle runs and is driven. Reasons for it not cranking could range from a booster pack that doesn't have the amperage to turn over a...
Forum: Prospective Buyers - Question and Answer Forum Yesterday, 09:13 AM
Replies: 3
Views: 77
Posted By RamTech
The need to keep gassing the engine is because...

The need to keep gassing the engine is because the PCM lost it's idle strategy due to a dead battery and has to relearn it - no big deal. Did the oil smell like gas?
Forum: Dodge Ram General Discussion Yesterday, 08:59 AM
Replies: 25
Views: 622
Posted By RamTech
I'm talking from a technicians standpoint....

I'm talking from a technicians standpoint. There's only so much Chrysler will pay us to do, and anything beyond that comes from our own generosity.
Forum: Dodge Ram General Discussion Yesterday, 08:58 AM
Replies: 25
Views: 622
Posted By RamTech
Of all the engines I've repaired instead of...

Of all the engines I've repaired instead of replaced, none of them has yet to return for an engine problem.
Forum: Electrical 03-02-2015, 11:55 AM
Replies: 2
Views: 74
Posted By RamTech
I suspect the fuel level sending unit is faulty,...

I suspect the fuel level sending unit is faulty, but it could also be the PCM, the fuel gauge itself, or a wiring issue. You can easily perform a gauge self test - With the key off, press and hold...
Forum: 2009 Dodge Ram Forum 03-02-2015, 11:29 AM
Replies: 1
Views: 42
Posted By RamTech
If you've mixed types of fluid (specifically blue...

If you've mixed types of fluid (specifically blue and then a deicing formula) you probably have a gummed up pump inlet. Remove the pump motor and have a look - chances are, you can clean it out. If...
Forum: 2010 Dodge Ram Forum 03-02-2015, 11:26 AM
Replies: 1
Views: 79
Posted By RamTech
You may have bent one of the wiper transmission...

You may have bent one of the wiper transmission arms.
Forum: Electrical 03-02-2015, 10:56 AM
Replies: 1
Views: 42
Posted By RamTech
Yes, bulbs in the cluster are replaceable, but I...

Yes, bulbs in the cluster are replaceable, but I don't have the part number handy. I'm sure someone here knows it off the top of their head.
Forum: 5.9L V8 Specific Topics 03-02-2015, 10:48 AM
Replies: 2
Views: 51
Posted By RamTech
If it feels like it's running out of fuel, start...

If it feels like it's running out of fuel, start with a fuel pressure and volume test.
Forum: Dodge Ram General Discussion 03-02-2015, 10:31 AM
Replies: 25
Views: 622
Posted By RamTech
A savvy tech can get by that 70% rule for a short...

A savvy tech can get by that 70% rule for a short block pretty easily. The trick is to condemn the cam bearings for scoring. Since Chrysler doesn't offer cam bearings separately, the only way to get...
Forum: 5.7L V8 Specific Topics 03-02-2015, 09:09 AM
Replies: 4
Views: 83
Posted By RamTech
Since you've changed the stat, and I presume...

Since you've changed the stat, and I presume there are no visible leaks, I would suggest either replacing or at least pressure testing the radiator cap.
Forum: Custom Dodge Ram Interior and Exterior Lighting 02-28-2015, 09:05 AM
Replies: 11
Views: 199
Posted By RamTech
I can't imagine it would hurt anything since...

I can't imagine it would hurt anything since LED's are low current and it's not being used for anything else.
Forum: 2013 Dodge Ram Forum 02-28-2015, 09:03 AM
Replies: 16
Views: 1,056
Posted By RamTech
There might still be some out there. I'm not...

There might still be some out there. I'm not aware of any time limits being imposed for updates.
Forum: 5.7L V8 Specific Topics 02-28-2015, 09:02 AM
Replies: 6
Views: 88
Posted By RamTech
Since this started after the installation of new...

Since this started after the installation of new plugs, I would go back and double check everything that was just done and make sure you didn't either leave something loose or disconnected or that a...
Forum: 5.7L V8 Specific Topics 02-27-2015, 03:25 PM
Replies: 4
Views: 83
Posted By RamTech
Sure you don't have air trapped in the system?

Sure you don't have air trapped in the system?
Forum: 5.7L V8 Specific Topics 02-27-2015, 12:36 PM
Replies: 6
Views: 88
Posted By RamTech
I'm leaning toward an EGR issue at the moment....

I'm leaning toward an EGR issue at the moment. Scan the PCM anyway - the lack of a MIL doesn't mean there aren't stored codes.
Forum: Custom Dodge Ram Interior and Exterior Lighting 02-27-2015, 09:27 AM
Replies: 11
Views: 199
Posted By RamTech
The wires should be either PK with LB/BK or PK...

The wires should be either PK with LB/BK or PK and LB/BR. The circuit originates at fuse 51.
Forum: Dodge Ram General Discussion 02-27-2015, 09:22 AM
Replies: 15
Views: 264
Posted By RamTech
This doesn't apply to the Hemi, just the older...

This doesn't apply to the Hemi, just the older 5.2/5.9 engines.
Forum: Electrical 02-27-2015, 09:20 AM
Replies: 5
Views: 136
Posted By RamTech
Best of luck. I'll be looking forward to...

Best of luck. I'll be looking forward to following your progress.
Forum: 2013 Dodge Ram Forum 02-27-2015, 09:19 AM
Replies: 16
Views: 1,056
Posted By RamTech
They will be done automatically as long as the...

They will be done automatically as long as the truck is under warranty. After that, it's your responsibility to pay for them.
Forum: 2011 Dodge Ram Forum 02-26-2015, 02:49 PM
Replies: 8
Views: 170
Posted By RamTech
I haven't seen any documentation as of yet, but...

I haven't seen any documentation as of yet, but perhaps there's a flash update that addresses the issue.
Forum: 2013 Dodge Ram Forum 02-26-2015, 02:42 PM
Replies: 3
Views: 133
Posted By RamTech
That, I don't have an answer for.

That, I don't have an answer for.
Forum: Dodge Ram General Discussion 02-26-2015, 12:38 PM
Replies: 3
Views: 86
Posted By RamTech
Did you scan it with a tool capable of scanning...

Did you scan it with a tool capable of scanning all the modules or just a generic that does PCM, ABS, and SRS?
Forum: 5.9L V8 Specific Topics 02-26-2015, 10:54 AM
Replies: 1
Views: 43
Posted By RamTech
Bad axle u-joint would be a fair guess,...

Bad axle u-joint would be a fair guess, especially if it's just dried out inside but hasn't yet chewed up the needle bearings.
Forum: 2013 Dodge Ram Forum 02-26-2015, 09:59 AM
Replies: 3
Views: 133
Posted By RamTech
Yes, it is normal because the technician had to...

Yes, it is normal because the technician had to perform an update to the system that lets it know there's now a camera installed. This process will wipe out many of your optional settings.
Showing results 1 to 25 of 500

 
Forum Jump


Advertisement






All times are GMT -4. The time now is 03:04 AM.


= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
vB.Sponsors


=Gigathreads Network=
CLUBS MOPAR NATION DSM GPMM MAMM JAM
DIESEL Diesel Forum      
CHEVY Chevy Camaro Forum Chevy Volt Forum    
CHRYSLER Chrysler 300C Forum      
DODGE Dodge Avenger Forum Dodge Caliber Forum Dodge Challenger Forum Dodge Charger Forum
  Dodge Circuit Forum Dodge Hornet Forum Dodge Magnum Forum Dodge Nitro Forum
  Dodge Ram Forum Dodge Dakota Forum Dodge Durango Forum Dodge Dart Forum
FORD Ford Raptor Forum Ford F150 Forum Ford F100 Forum  
JEEP Jeep Forum      
PONTIAC Pontiac G8 Forum      
SRT SRT Viper Forum SRT Cuda Forum